The Methods Used to Provide the Reliability of Gas Bleeding Ducts for EPP Boilers
DOI:
https://doi.org/10.20998/2078-774X.2017.11.07Анотація
Erosion and corrosion damage of the elements of electric equipment is one of the main reasons for the normal operation disturbance and sometimes lockup of the thermal power equipment. The metal loss in the elements of power plants due to the erosion and corrosion wear over their entire service life exceeds 8 % of the original mass that results in the efficiency reduction. In addition, erosion and corrosion process products cause the blockage of water-steam circuit which negatively affects a reliable operation of the power equipment. The purpose of this research was to study the influence of the temperature of dew point on the reliability control. The domestic literature describes some relationships used for the definition of sulfuric acid dew point that were obtained using the dust firing technique. This method allows for the computation of temperature differences and the method showed that that temperature of sulfuric acid dew point exceeds that of the dew point of pure vapors (tр = 45–54 °С). To meet a condition of the prevention of condensate formation it is necessary to increase the temperature of the internal surface of gas bleeding circuit ts and decrease the humidity of furnace gases and thus decrease the temperature of their dew point tр. The technological areas of the disposal of furnace gases with no water steam condensation include the heat transfer to the water in the additional heating surface; additional heat transfer to the blow air through an increase in the temperature difference due to a decrease in the temperature of entering air, and the additional heat transfer to the feed water in available heating surfaces.Посилання
Yelsukov, V. K. (2007), "Evaluation of the possibility of utilization of exhaust gases heat the boilersattheexampleofburningKansk-Achinsk coals", Promyshlennaya Energetika, No. 11, pp. 21–27.
Hvorenkov, D. A. and Varfolomeeva, A. S. (2005), "To the question of kondensatornii in chimneys of boilers",Plumbing.Heating. Conditioning, No. 8, available at: http:// www.c-o-k.ru (accessed 3 January 2017).
Bukharkin, E. N. (1995), "The issue of providing safe conditions of use of fuel-efficient boilers with condensingheatexchanger", Promyshlennaya Energetika, No. 7, pp. 31–34.
Afanasev, Y. A., Petrik, P. T., Tiunova, N. In. and Kalmykov, A. S. (2002), "Study of steam condensation from steam-airmixtures", Bulletin of the Kuzbass state technical University, No. 3, pp. 49–52.
Kutateladze, S. S. (1952), Heat transfer during condensation and boiling, Mashgiz, Moscow, Russian.
Fialko, N. M., Aronov, I. S., Navrotsky, R. A. and Presic, G. A. (2003), "The efficacy of the condensing heat exchangerinheat supply systems", Industrial heat engineering, Vol. 25, No. 3, pp. 36–41.
Guth, P. A., Kruk, M. T. and Misak, I. S. (1999), "Corrosion Protection of external surfaces during idle boilers inreserve",Bulletin of State University "Lviv Polytechnic", No. 365, pp. 47–55.
(1986), МУ З4-70-118-84. Guidelines for the prevention of low temperature corrosion of the heating surfaces and flues oftheboiler. Moscow, Russian.
Lipov Y.M., Tretiyakov Y.M. Boiler plants and steam generators (2006) Moscow, Izhevsk, Institute of Computer Studies.
Aleksandrov, B., Beeman, V. M., Laricheva, А. А., Lipiec, A. U. and Prokhorova, A. I. (1965), "Way to protect vazduhoplov-greates from corrosion", SU180284 (USSR). No. 100365, Appl. 26.04.1965, publ. 01.01.1966, bull. No. 7.
Fenimore, C. (1972), Formation of nitric oxide from fuel nitrogen in ethyltnt", Combustion and Flames, Vol. 19, No. 2,pp.289–296.
Sazanov, B. V. and Sitas, V. I. (1990), Heat power engineering systems of industrial enterprises, Energoatomizdat,Moscow,Russian.
Smirnov, I. A. and Khrilev, L. S. (2004), "The Main directions of improving the efficiency of CHP in the conditions ofmarketrelations", Thermal Engineering, No. 4, pp. 50–57.
Zhydovich, O. V., Alshevsky, V. N. and Dugih, F. P. (1977), "Cooling of gases in chimneys", Teploenergetika, No. 9, pp. 44–47.
Besludniy, P. P., Semeniuk, L. G., Nikolaev, V. N. and Peresichna, M. I. (1986), "Determination of the dew pointtemperatureof the combustion products of natural gas", Izvestiya vuzov of the USSR. Energy, No. 12, pp. 89–91.
